SurfaPaint ThermoDry Exterior Paint
SurfaPaint ThermoDry Exterior can be applied directly on exterior wall surfaces (masonry, concrete, plaster, drywalls), and wherever water based, acrylic paints are applied. New substrates from cement or masonry should have cured for more than 3-4 weeks before primer application. Adverse conditions during or immediately after application may affect the coating’s properties.

Preparation: Ensure all surfaces are clean and dry prior to application. Remove any dust and dirt. Application note: Stir well before application. Do not dilute for bridging gaps and hairline cracks of up to 0.5 mm. For cracks bigger that 1mm, fill the gap with a suitable putty. If thinning is required add up to 10% water by volume. Application temperature should be between 8 - 35oC. Apply 2-3 even coats using a good quality brush, roller or by spraying with a tip of a diameter 1.4mm or more. Do not over-brush. Ensure corners and edges are adequately covered. Additional coats should be applied 4-6 hours after the previous application.

Spreading Rate: 10-12 m2/L.

Available Packaging: 10L pails.